Oven Door Removal; Oven Door Hinge Receiver; Side Panel Removal; Backguard - Maytag AER5515QA Series Service Manual

Disassembly Procedures
!

Oven Door Removal

!
WARNING
To avoid risk of personal injury or property damage,
do not lift oven door by the handle.
1. Open oven door and place door hinge locking device
into lock postion.
2. Place oven door in first stop position, then grasp both
sides and lift up off the hinge receivers.
Lock
Position
3. Reverse procedure to reinstall oven door.
NOTE: Verify the door hinge locking device is in the
lock postion before closing the oven door.

Oven Door Hinge Receiver

1. Turn off power to unit.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 5, and "Drip Baffle"
procedures (if so eqipped).
4. Remove side panel, see "Side Panel Removal"
procedures.
5. Remove the top and bottom screws securing hinge
receiver to the front frame.
6. Remove hinge receiver from oven chassis.
7. Reverse procedure to reinstall oven door hinge
receiver.

Side Panel Removal

1. Turn off power to unit.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 5.
4. Remove screws securing lower rear galvanized cover
from unit.
26
WARNING
Unlock
Position
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
5. Remove screws securing top and back of side panel.
6. Pull rear of side panel away from range then slide
side panel forward to release from side panel
spacers.
7. Reverse procedure to reinstall side panel.

Backguard

NOTE: Requires removal of oven from installation
position.
1. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 5.
2. Remove screws securing upper back panel form unit.
3. Remove screws securing bottom outside edges of the
backguard to unit chassis.
4. Reverse procedure to reinstall backguard.

Storage Drawer Removal

1. Pull drawer straight out to first stop. Lift the front and
pull out to second stop.
2. Let front of door rest on floor. Place hands toward
back of drawer and lift it out.
3. To replace:
a. Place the set of rollers on the drawer behind the
set of rollers on the oven. (As shown above.)
b. Align the guides and push the drawer back into
position.
Storage Drawer Track Removal
1. Remove the storage drawer by pulling it out to the
fully open or stop position, lifting the drawer at the
rear to disengage the drawer track rollers from the
drawer runners, and sliding the drawer out of the
range.
2. The tracks are mounted to a rear support and the
frame of the range. Remove the two track mounting
screws and remove the track. If the track support is
being replaced, remove the mounting screw securing
it to the side frame and remove the support.
16025644
©2004 Maytag Services