Disassembly Procedures; Removing And Replacing Oven; Maintop Assembly; Control Panel - Maytag AER5515QA Series Service Manual

Disassembly Procedures

!

Removing and Replacing Oven

1. Turn off power to the oven at the circuit breaker.
2. Pull the oven forward out of the cabinet opening.
3. Disconnect or unplug the power cord leading from
unit to fuse box or junction box depending on unit.
4. Replace the oven using the installation instructions
and anti-tip bracket(s).

Maintop Assembly

1. Turn power off to unit.
2. Open oven door and remove screws securing
maintop to oven chassis, located on the out side
edges of the maintop.
3. Raise the front edge of the maintop and pull forward
approximately 6-inches.
4. Disconnect wire terminal plugs from the maintop
assembly.
5. Lift maintop assembly from the oven chassis.
6. Reverse procedure to reinstall maintop assembly.

Control Panel

1. Remove maintop assembly, see "Maintop Assembly"
procedure,
steps 1 through 5.
2. Remove screws securing control panel heat sheild.
3. Remove screws securing bottom outside edges of the
control panel.
4. Pull unit out from the wall far enough to allow the
back outside screws to be loosened.
5. Loosen the back outside scews securing control
panel to backguard.
6. Grasp front lower outside edges of the control panel
and push inward on the outside edges of the
backguard to release the control panel front.
NOTE: Front edges of the control panel are difficult to
release from backguard.
7. Once the control panel bottom edges are free, pull
control panel forward and raise the control panel
upward to release screws securing top back edges
and allow control panel to tip forward.
8. Reverse procedure to reinstall control panel.

Control Board Assembly

1. Remove control panel, see "Control Panel"
procedure, steps 1 through 6.
2. Remove screws securing control board bracket to
control panel.
3. Label and disconnect terminal plug from control board
assembly.
4. Reverse procedure to reinstall control board
assembly.
24
WARNING
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.

Infinite Switch

1. Remove control panel, see "Control Panel" procedure
for removal.
2. Disconnect and label wire terminals from infinite
switch.
3. Remove knob on infinite switch being replaced.
4. Remove screws in front securing infinite switch to
control panel.
5. Reverse procedure to reinstall infinite switch.

Indicator Lights

1. Remove control panel, see "Control Panel" procedure
for removal.
2. Disconnect and label wire terminals from indicator
light.
3. Slide indicator light while hold the lens from the front
to release from control panel.
4. Reverse procedure to reinstall indicator light.

Rocker Switch

1. Remove control panel, see "Control Panel" procedure
for removal.
2. Disconnect and label wire terminals from rocker
switch.
3. Squeeze tabs on rocker switch and push outward to
release from control panel.
4 . Reverse procedure to reinstall indicator light.

Oven High Limit

NOTE: Requires removal of oven from installation
position.
1. Turn off power to unit.
2. Remove lower rear access panel.
3. Disconnect and label wire terminals connected to limit
switch.
4. Remove screws securing high limit switch.
5. Reverse procedure to reinstall switches.
16025644
©2004 Maytag Services