Remove Oven Door(S) - Maytag YMET8800FZ Installation Instructions Manual

If range does not operate, check the following:
Household fuse is intact and tight; or circuit breaker has not
■
tripped.
Range is plugged into a grounded outlet.
■
Electrical supply is connected.
■
The range is designed to not need the oven doors removed
■
for standard usage and cleaning, however, they can be
removed if necessary.
Do not lift or move the range by the door handle(s).
■
Prepare a surface where you will place the door(s). This
■
surface should be flat and covered with a soft blanket, or use
the corner posts from the packaging material.
A. Oven door hinge in the
locked position
B. Oven door hinge in the
unlocked position
Partially close the door to engage the
door latch locks. The door will stop at
this point.
■

Remove Oven Door(s)

A
B
■
■
See the "Troubleshooting" section in the Use and Care
Guide.
When the range has been on for 5 minutes, check for
■
heat. If range is cold, turn off the range and contact a
qualified technician.
Use two hands to remove and replace
the oven door(s). It may be necessary to
gently shift door from side to side.
A. Slot in the oven frame for the door
hinge lock
To replace the oven door(s), locate the slots in the oven
cavity for the hinge locks and repeat the steps above in
reverse order. Make sure the door closes properly and there
is no interference from the door latch. If necessary, remove
the door and repeat the steps above. If power is connected
to the range, open and close the door to make sure the oven
light comes on and goes off appropriately.
Follow the installation instructions found in the bag
containing the literature.
A
13