Elation DMX-SOLO 256 User Manual page 23

2. Operation Guide
2.5 Playback one or more Chases or Memories
3
CHASE 1-40
2.6 Audio Chase/Memory
3
AUDIO/DEL
2.7 Send Record Data
9 10 11 12
3. When Chase LED flashes, two or more Chases or
Memories can be selected at a time. If you select
several Chases or Memories, these Chases or
Memories shall be sequential in the order you
select.
1. When the chase or memory is playing, you may tap
AUDIO/DEL button, its LED is lit, which refers to that
Audio mode is active, the chase or memory shall be
subject to the audio signal detected by built-in Mic.
2. Tap AUDIO/DEL button again causing its LED to go
out, the chase or memory will not be activated by the
audio signal.
1. You must set up proper DMX connection between two
unit before you can send or receive record data.
2. Turn the power off. While pressing buttons 9, 10, 11,
and 12, turn the power on. If the content of this unit is
empty, the Segment Display shall show "EMPT" . If the
content contains scenes or chases, the Segment
Display shall show "OUT", which means this unit is
ready to send record data.
20