Use Your Baby Monitor - Philips AVENT SCD505 User Manual

5 Use your baby
monitor
Link the parent unit to the baby unit:
1
Press and hold
seconds.
» The baby unit turns on, and all
indicators on the baby unit light up
briefly.
2
Press and hold
two seconds.
» The parent unit turns on, and all
indicators on the parent unit light up
briefly.
» The link indicator flashes red and the
parent unit starts to search for the
baby unit.
» When link is established, the link
indicator lights up green.
EN
10
on the baby unit for two
on the parent unit for
» If no link is established, the link
indicator flashes red. The parent unit
beeps from time to time.
Tip
•
It takes less than 15 seconds to establish the link
between the parent unit and the baby unit.
Position the baby monitor:
Note
•
For the optimal monitoring performance, keep the baby
unit 1 to 2 metres (3.5 to 7 feet) away from the baby.
•
Place the baby unit away from window or noisy
sources, like a fan, TV, or radio.
•
The baby unit should always face towards the baby.
1
Keep the baby unit and the mains cord at
least 1 metre/3.5 feet away from your baby.
2
Keep the parent unit at least 1.5 metres/5
feet away from the baby unit to prevent
acoustic feedback.
3
Use the parent unit in the operating range
of the baby monitor. Place the parent unit
close by for better sound performance.
Tip
•
When the parent unit is out of range of the baby
unit, the parent unit beeps from time to time. The link
indicator on the parent unit flashes red.
•
The battery indicator flashes red and a beep tone
occurs 30 minutes before the batteries run out of
power.