Kodak ESP 5200 Series Extended User Manual page 11

Before you connect
Connecting to a
wireless network
using the WiFi
Setup Wizard
Connecting to a
listed network
You need:
• A laptop or desktop computer equipped with a network interface card or
wireless networking support.
• A working 802.11 wireless network. Kodak recommends that you use a wireless
access point/router that uses Dynamic Host Configuration Protocol (DHCP).
• Your network name (SSID - Service Set Identifier). You can obtain your SSID
from the wireless access point, most commonly a router, using the router's
embedded Web server. See the manufacturer's documentation provided with
your wireless system for more information.
• Your Wired Equivalent Privacy (WEP) key or Wi-Fi Protected Access
(WPA/WPA2) passphrase.
• To be sure to temporarily disable your firewall until the printer is successfully
installed and communicating.
For assistance with any of the items listed above, contact your Internet service
provider or your network administrator.
You can use the WiFi Setup Wizard on the printer to connect to your wireless
network. Read the following procedures and use the one that is appropriate for your
network setup.
See Before you connect
network. For assistance, contact your Internet service provider or your network
administrator.
To connect to a listed network using the WiFi Setup Wizard:
1. Press Home .
2. Press to select Network Settings , then press OK .
3. With WiFi Setup Wizard selected, press OK .
NOTE: The Wi-Fi radio is turned on automatically when you select WiFi Setup
Wizard.
The printer searches for available wireless networks within range, then displays
the list in order of signal strength. For example:
www.kodak.com/go/aiosupport
KODAK ESP 5200 Series All-in-One Printer
to determine what is needed to connect your printer to the
6