Removing The Hanger Bar - Whirlpool Personal Valet PVBN600 Service Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1. Unplug the clothes vitalizer or disconnect
the power.
2. Remove the clothes vitalizer from the wall
and position it so that you can access the
rear of the unit.
3. Remove the two hanger bar hex-head
screws from the rear of the unit.
Rear Hanger
Bar Screws

REMOVING THE HANGER BAR

4. Open the cabinet doors.
5. Using a small-bladed screwdriver, pry the
plastic medallion out of the recess in the
holder in front of the hanger bar.
6. Remove the flathead screws from the
hanger bar support and remove the hanger
bar. Hold the bar so that it does not fall
when the screws are removed.
Screwdriver
Pry Off Plastic
Medallion With
Screwdriver
5-11
Hanger Bar
Remove Two Flat-
head Screws