Grandstream Networks GXP2124 User Manual page 53

SIP URI
Click-To-Dial Feature
Call History Flash Writing:
Write Timeout
Call History Flash Writing:
Max Unsaved Log
Settings -> Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Busy Tone
Reorder Tone
Call Waiting Tone Gain
Settings -> Audio Control
Headset Key Mode
FIRMWARE VERSION 1.0.6.11
The default setting is "No".
Enables Click-To-Dial feature. The default setting is "Disabled".
Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
Configures ring or tone frequencies based on parameters from local
telecom. The default value is North American standard. Frequencies
should be configured with known values to avoid uncomfortable high
pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise
it will ring ON ms and a pause of OFF ms and then repeat the pattern. Up
to three cadences are supported.
Configures the call waiting tone gain to adjust call waiting tone volume.
The default setting is "Low".
When headset is connected to the phone, users could use the HEADSET
button in "Default Mode" or "Toggle Headset/Speaker".

Default Mode:
 When the phone is in idle, press HEADSET button to off hook
the phone and make calls by using headset. Headset icon will
display on the screen in dialing/talking status.
 When there is an incoming call, press HEADSET button to pick
up the call using headset.
 When there is an active call using headset, press HEADSET
button to hang up the call.
 When Speaker/Handset is being used in dialing/talking status,
press HEADSET button to switch to headset. Press it again to
hang up the call. Or press speaker/Handset to switch back to the
previous mode.

Toggle Headst/Speaker:
GXP2124 USER MANUAL Page 51 of 75