Code Requirements / References - Pentair MASTERTEMP 200 HD Installation And User Manual

CODE REQUIREMENTS / REFERENCES

Gas Safety (Installation and Use) Regulations, (as amended).
It is the law that all gas appliances are installed by a competent person (e.g. a CORGI registered operative) in accordance with Regulations.
Failure to install appliances correctly could lead to prosecution.
The installation of the Heater MUST also be in accordance with the
current I.E.E.. Wiring Regulations, the Local Building Standards (Scotland), the Bye Laws of the Local Water Undertaking, any relevant require-
ments of the Local Authority, and Health and Safety document No 635, "Electricity at Work Regulations".
Detailed recommendations are contained in the following British Standard Codes of Practice.
Installation must be in accordance with the code requirements:
Manufacturer's Installation Instructions
•
• Local Gas Fitting Regulations
• Municipal Building Codes
• EN 437: 2003 + A1 (2009) Test Gases - Test
pressures appliances categorizes.
• EN 60335-2-102/A1 - Household and similar
electric appliances - Safety - 2- 2012
• BS 6891 Specification for installation of
low pressure gas pipe work.
• BS5482:1 Code of practice for domestic
butane and propane gas burning
installations. Building Regulations|
Part L1.
IMPORTANT NOTICE:
DO NOT directly connect any external control device to this appliance, unless noted in this Installation and User's Guide
or recommended by the manufacturer. Any installed control device not recommended by the manufacturer could violate
the Gas Safety Regulations (the installation and use), the above described regulations and the appliance warranty.
The manufacturer's notices DO NOT supersede any legal requirements.
P/N 475106 Rev. A 2/2014
Code Requirements / References |
• Local Electrical Regulations
• Any other statutory regulations
• EN 15502-1 : 2012 Gas fired heating
boilers general requirements test.
• BS 6644 : 2011 Specifications for
the installation and maintenance of
gas fired hot water boilers between
70Kw - 1.8 mW, (2nd. and 3rd. gas
family).
MASTERTEMP ™ Pool and Spa Heater Installation and User's Guide
iV