Outdoor Installation / Heater Clearances - Pentair MASTERTEMP 200 HD Installation And User Manual

OUTDOOR INSTALLATION
For heaters located outdoors, using the built-in stackless venting system.
CARBON MONOXIDE GAS IS DEADLY – Exhaust from this pool heater contains carbon monoxide, a dangerous, poisonous
gas you cannot see or smell. Symptoms of carbon monoxide exposure or poisoning include dizziness, headache, nausea,
weakness, sleepiness, muscular twitching, vomiting and inability to think clearly. IF YOU EXPERIENCE ANY OF THE ABOVE
SYMPTOMS, IMMEDIATELY TURN OFF THE POOL HEATER, LEAVE THE VICINITY OF THE POOL OR SPA AND GET INTO
FRESH AIR IMMEDIATELY. THE POOL HEATER MUST BE THOROUGHLY TESTED BY A GAS PROFESSIONAL BEFORE
RESUMING OPERATION.
EXCESSIVE CARBON MONOXIDE EXPOSURE CAN CAUSE BRAIN DAMAGE OR DEATH.
Risk of explosion if a unit burning propane gas is installed in a pit or other low spot. Propane is heavier than air. Do not
install the heater using propane in pits or other locations where gas might collect. Consult the British Standard Codes of Practice
building code officials to determine installation requirements and specific installation restrictions of the heater relative to
propane storage tanks and filling equipment. Installation must meet the requirements for the Standard for the Storage and
Handling of Liquid Petroleum Gases. Consult local codes and fire protection authorities about specific installation restrictions.
Locate the heater in an open, unroofed area and on a level surface
that is protected from drainage or run-off. Install the heater in an
area where leaves or other debris will not collect on or around the
heater.
It is recommended that a non-combustible base be a platform under
the heater constructed of hollow masonry blocks, not less than
100 millimeters (mm) thick (laid with ends unsealed and joints
matched for air circulation). Cover blocks with 0.75 mm (min.)
galvanized sheet metal, see
To avoid damage to the electronic components in the heater, take
care to prevent prolonged exposure to driving sources of water
(such as lawn sprinklers, heavy roof runoff, hoses, etc.). Avoid
operation in persistent, extreme, moist or salty environments.
In extreme weather, shut down the heater and disconnect the power
to it until the weather has moderated. In areas subject to hurricanes
or very high winds, purchase the Bolt Down Bracket Kit,
P/N 460738, see Figure 16.
P/N 475106 Rev. A 2/2014
(UNITED KINGDOM)
WARNING
Figure 15.
DANGER
BASE FOR USE ON
COMBUSTIBLE FLOORS
SHEET
METAL
BLOCKS
Hollow masonry blocks, not less than 100 mm thick, (laid with ends unsealed and joints
matched for air circulation). Cover blocks with 0.75 mm (min.) galvanized sheet metal.
Figure 16.
MASTERTEMP ™ Pool and Spa Heater Installation and User's Guide
Section 2. Installation
Figure 15
.
For Heater mounting
bolts and clamps,
purchase separately
Bolt Down Bracket Kit,
Part No. 460738.
Lead
Anchor
| 13