Keys And Remote Controls; General Information On Radio; Frequencies; Remote Control - Ford FIESTA Owner's Manual

GENERAL INFORMATION ON
RADIO FREQUENCIES
Note: Changes or modifications not
expressly approved by the party responsible
for compliance could void the user s
authority to operate the equipment.
The typical operating range for your
transmitter is approximately 33 ft (10 m).
A decrease in operating range could be
caused by:
• weather conditions
• nearby radio towers
• structures around your vehicle
• other vehicles parked next to your
vehicle.
The radio frequency used by your remote
control can also be used by other radio
transmitters, for example amateur radios,
medical equipment, wireless headphones,
wireless remote controls, cell phones,
battery chargers and alarm systems. If the
frequencies are jammed, you will not be
able to use your remote control. You can
lock and unlock the doors with the key.
Note: Make sure your vehicle is locked
before leaving it unattended.
Note: If you are in range, the remote control
will operate if you press any button
unintentionally.
Note: The remote control contains sensitive
electrical components. Exposure to moisture
or impact may cause permanent damage.
Fiesta (CCN) Vehicles Built From: 12-01-2015 Vehicles Built Up To: 14-10-2015, CG3582en enGBR, Edition date: 12/2014, First Printing

Keys and Remote Controls

REMOTE CONTROL

You can program a maximum of eight
remote controls to your vehicle. This
includes any that were supplied with your
vehicle. The remote controls must remain
inside your vehicle during the programming
procedure. Fasten the front safety belts
and close all doors to make sure that
conflicting chimes do not sound during
programming.
Programming a New Remote
Control
1. Turn the ignition key from position 0 to
position II four times within six
seconds.
2. Turn the ignition to position 0. A tone
sounds to indicate that it is now
possible to program a remote control.
Note: If a tone does not sound, repeat step
1, this time turning the ignition key from
position 0 to position II 8 times within 10
seconds, ending in position 0. A tone sounds
to indicate that it is now possible to program
a remote control.
3. Press any button on a new remote
control within 10 seconds. A tone will
sound as confirmation.
4. Repeat step three within 10 seconds
for each new remote control. Do not
remove the key from the ignition when
pressing the button on the remote
control.
5. Switch the ignition back on (position
II) or wait for 10 seconds without
programming another remote control
to end the key programming. Only the
remote controls which you have just
programmed are now able to lock and
unlock your vehicle.
27