Cruise Control; Principle Of Operation; Using Cruise Control - Ford FIESTA Owner's Manual

PRINCIPLE OF OPERATION

WARNING
The system does not relieve you of
your responsibility to drive with due
care and attention.
Cruise control allows you to control your
speed using the switches on the steering
wheel. You can use cruise control when
you exceed approximately 20 mph (30
km/h).

USING CRUISE CONTROL

WARNINGS
Do not use cruise control on winding
roads, in heavy traffic or when the
road surface is slippery. This could
result in loss of vehicle control, serious
injury or death.
When you are going downhill, your
speed may increase above the set
speed. The system will not apply the
brakes. Change down a gear to assist the
system in maintaining the set speed.
Failure to do so could result in loss of
vehicle control, serious injury or death.
The cruise controls are located on the
steering wheel.
Fiesta (CCN) Vehicles Built From: 12-01-2015 Vehicles Built Up To: 14-10-2015, CG3582en enGBR, Edition date: 12/2014, First Printing

Cruise Control

124
(If Equipped)
Note: Cruise control will disengage if your
vehicle speed decreases more than 10 mph
(16 km/h) below your set speed while
driving uphill.
Switching Cruise Control On
Press and release ON.
Setting the Cruise Speed
1. Accelerate to the desired speed.
2. Press and release SET+. The indicator
displays in the instrument cluster.
3. Take your foot off the accelerator
pedal.
Changing the Set Speed
• Press and hold SET+ or SET-. Release
the control when you reach the desired
speed.
• Press and release SET+ or SET-. The
set speed will change in approximately
1 mph (2 km/h) increments.
• Press the accelerator or brake pedal
until you reach the desired speed. Press
and release SET+.
Canceling the Set Speed
Press and release CAN, or tap the brake
pedal. The indicator no longer displays in
the instrument cluster. The set speed will
not be erased.
Note: For vehicles with manual
transmission, depressing the clutch pedal
will also cancel the set speed.
Resuming the Set Speed
Press and release RES. The indicator
displays in the instrument cluster.