Table of Contents
Advertisement
7.
Lift the SAS/SATA HDD and HDD tray assembly using the handle then place it into
the HDD bay. Ensure that the SAS/SATA connector of the SAS/SATA HDD is aligned
towards the SATA connector onboard and the four (4) notches on the HDD tray
matches the four (4) contours on the drive bay.
8.
Push down the HDD tray handle until the HDD and HDD tray assembly locks in place.
9.
Ensure that the HDD and HDD tray assembly is seated securely in place.
Check the status of the LEDs at the front panel on the particular drive you just installed.
2-16
Chapter 2: Hardware setup
Advertisement
Table of Contents
