Front Of The Switch; Network Ports; Console Port - HP 2510-24 Installation And Getting Started Manual

Introducing the Switch

Front of the Switch

Front of the Switch
Power, Fault
Test Status LED
and Locator
LEDs
*
Spd mode: off = 10 Mbps, flash = 100 Mbps, on = 1000 Mbps
ProCurve Switch
Link 1 3 5 7
2510-24 Mode
J9019A
Power
Fault
Act
Locator LED
Mode
FDx
*
Test Spd
Link 2 Mode 4 6 8
Reset Clear
Console
LED Mode select button
and indicator LEDs

Console port

Reset and Clear
buttons

Network Ports

■
■
Dual-Personality Port Operation. By default, the RJ-45 connectors are
enabled. If a mini-GBIC is installed in a slot, it is enabled and the associated
RJ-45 connector is disabled and cannot be used. If the mini-GBIC is removed,
the associated RJ-45 port is automatically re-enabled.
Console Port
This port is used to connect a console to the Series 2510 Switch by using the
supplied cable with the switch. The console port is located on the front of the
Switch. This connection is described under "Connect a Console to the Switch"
in chapter 2, "Installing the Switch." The console can be a PC or workstation
running a VT-100 terminal emulator, or a VT-100 terminal.
1-2
Switch port LEDs
10/100Base-T Ports (1 - 24) — Ports are HP Auto MDI-X
9 11 Link 13 15 17 19 21 23
Mode
10 12 Link 14 Mode 16 18 20 22 24
10/100Base-TX RJ-
45 ports*
* 10/100/1000Base-T ports have the IEEE Auto MDI/MDI-X feature.
24 auto-sensing 10/100Base-TX ports.
All these ports have the "IEEE Auto MDI/MDI-X" feature, which means
you can use either straight-through or crossover twisted-pair cables to
connect any network devices to the switch.
Two dual-personality ports. Use either the 10/100/1000Base-T RJ-45
connector, or install a supported ProCurve mini-GBIC for fiber-optic
connections.
The RJ-45 connectors support the IEEE Auto MDI/MDI-X feature, which
means you can use either straight-through or crossover twisted-pair
cables to connect any network device to the switch.
25 26
Link T Mode T
Dual-Personality Ports:
10/100/1000-T (T)
or Mini-GBIC (M)
Link Mode
25 26
M M
Use only one (T or M)
!
for each Port
Dual-personality ports
(10/100/1000Base-T* or
mini-GBIC)
ProCurve Switch 2510-24