Rack Mounting The Switch 2510-24 - HP 2510-24 Installation And Getting Started Manual

Installing the Switch
Installation Procedures

Rack Mounting the Switch 2510-24

1.
8 mm
M4 screws
N o t e
The mounting brackets have multiple mounting holes and can be rotated
allowing for a wide variety of mounting options. These include mounting the
switch so its front face is flush with the face of the rack, or mounting it in a
more balanced position as shown in the illustration.
N o t e
Steps 2, 3, and 4 on the next page describe a convenient method of mounting
the switch in a rack by placing it on two screws that you first install in the
rack. You may, instead, just hold the switch with attached brackets up to the
rack and move it vertically until rack holes line up with the bracket holes and
notches, then insert and tighten the four screws holding the brackets to the
rack.
W A R N I N G
For safe reliable installation, only use the screws provided in the
accessory kit to attach the mounting brackets to the switch.
2-12
Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.