Hot-Plug Hard Disk Drives - Fujitsu PRIMERGY TX300 S5 Operating Manual

CSS components
Ê Slide the new power supply unit into the empty slot until the locking
mechanism engages.
I
Make sure that the power supply unit engages correctly in the slot and
is locked in position.
This is the only way to prevent the power supply unit from sliding out
of its mountings and being damaged during transportation.
Ê Connect the newly installed power supply unit.
8.1.2

Hot-plug hard disk drives

The hard disk drives which can be ordered for the PRIMERGY TX300 S5 are
supplied already mounted in an installation frame so that defective hard disk
drives can be replaced and new drives can be added during operation. The hard
disk drive and installation frame together make up the HDD module.
V
CAUTION!
The hard disk drive may not be removed from the installation frame
by anyone except a service technician.
The HDD modules (drives) must all be marked clearly so that they
can be put back in their original places after an upgrade. If this is not
done, existing data can be lost.
The hot-plug function is only possible in conjunction with a corre-
sponding RAID configuration.
Further information about the RAID configuration or RAID level can
be found in the RAID controller documentation.
TX300 S5
Operating manual
Hot-plug components
93