JVC KD-NX901 Service Manual page 30

4.6 NAVI engineer mode
Setup to the NAVI engineer mode
Turn on the power. Select to the [NAVI] mode
Press the key [SEL] [NAVI/AV] [OK] over the two seconds.
MENU
1.DIL FILE COPY
2.NAVILOG COPY
3.SENSOR DATA
NAVI ENGINEERING
1-30 (No.MA161)
4.GPS RAW DATA
5.SIMULATION DIL FILE COPY (For technical examination)
6.SYS_DATA COPY
NAVILOG COPY Copy log data to SD card at navigation guidance.
(Using troubleshooting to the designer)
SENSOR DATA
GPS LAW DATA (No use)
SIMULATION
SYS_DATA COPY (For technical examination)
Copy the log data file to SD card.
Learning Level:* Level(0-4)
Gyro:**** Gyro value (0000-4096)
**cm/pls: Centimeter per one pulse
Speed:**km/h Speed
**,*pps Pulse count of speed
Backgear:****** Direction
Low or High Position of back gear
GPS SAT:* Receive count of GPS saterite
HDOP:*,* HDOP value(0.0-99.9)
Change ON/OFF of the simulation mode.
Simulation mode : Using simulate with out sensor.
(It can use uncompleted Vp calibration.)
Display the sub menu after select the [SIMULATION]
1.OFF
2.ON
SIMULATION
Display after ON select.
SIMULATION MODE
JVC
The origin in simulation mode is determined as follows by language setup.
Language Origin
DANSK Copenhagen
DEUTSH Berlin
ENGLAND UK London
ENGLAND US London
ESPANOL Madrid
FRANCAIS Paris
ITALIANO Roma
NEDERLANDS Amsterdam
SVENSKA Stockholm
*Resetting the SIMULATION mode by the [ACC off] or power off or [RESET].