JVC KD-NX901 Service Manual page 16

3.1.11 Removing the switch board
(See Figs.19 to 21)
• Prior to performing the following procedure, remove the front
panel assembly.
(1) From the rear side of the front panel assembly, remove the
five screws X attaching the rear cover assembly to the front
panel assembly. (See Fig.19)
(2) Release the eight joints a of the front panel assembly and
remove the rear cover assembly. (See Fig.20)
(3) Take out the switch board from the front panel assembly.
(See Fig.21)
Caution:
Take care not to lose the spring.
1-16 (No.MA161)
X
Rear cover assembly
X
Fig.19
Joints a
Joints a
Rear cover assembly
Fig.20
Front panel assembly
Comp. spring
Fig.21
X
Joints a
Switch board