JVC KD-NX901 Service Manual page 14

3.1.9 Removing the rear bracket
(See Figs.16 and 17)
• Prior to performing the following procedure, remove the front
panel assembly, heat sink, top chassis assembly and main
board.
(1) Remove the two screws Q attaching the wire holder to the
rear bracket. (Figs.16)
(2) From the rear side of the main board, remove the wires
from the rear bracket in the direction of the arrow. (See
Fig.17)
(3) Remove the two screws R and screws S and U attaching
the rear bracket to the main board. (Figs.17)
(4) Remove the nut T attaching the GPS antenna terminal.
(See Fig.17)
(5) Disconnect the wire from the connector
board. (See Fig.16)
(6) Take out the main board from the bottom chassis assem-
bly.
1-14 (No.MA161)
CN381 on the main
Q
Wire holder
Rear bracket
Fig.16
R
Wire
S
Rear bracket
Fig.17
Main board
CN381
T
U