GMC 1990 Light Truck Repair Manual page 309

Figure 42—Removing Outer Deflector Ring
. _
18
PIPE COUPLING:
3" (K10/20)
4" (K30)
SQUARE UP DEFLECTOR RING AND TIGHTEN
NUT UNTIL RING BOTTOMS AGAINST SHOULDER
OF OUTER RACE
18. C/V Joint Outer Race
19. Deflector Ring
Figure 43—Installing Outer Deflector Ring
Figure 44—Removing C/V Joint
SHEET STEEL (3mm MIN
THICKNESS) WITH 28mm
1 g DRILLED HOLE
M24X2.0
NUT
F-6723
K TRUCK FRONT AXLE 4C4-23
" ►+ Install or Connect
.
Small seal-retaining clamp (11) on the neck of the new
1
seal (13). Do not crimp.
Slide the seal (13) onto the axle shaft (12) and position
the neck of the seal in the seal groove on the axle
shaft.
Crimp the seal-retaining clamp (11) with J 35910 to
136 N-m (100 ft. lbs.) (figure 46).
Place approximately half of the grease provided
inside the seal (13) and repack the C/V with the
remaining grease.
2 Swage ring (9).
.
Pinch by hand slightly to distort into an oval shape
and slide onto large diameter of the seal (13).
Push C/V joint onto axle shaft (12) until retaining ring
(14) is seated in groove on axle shaft.
Slide large diameter of the seal (13) with the large
swage ring (9) in place over the outside of the C/V joint
race (18) and locate the lip of the seal in the housing
groove.
PUSH ON JOINT ASSEMBLY
ONTO AXLE SHAFT UNTIL RETAINING
RING IS SEATED IN GROOVE ON AXLE SHAFT
12. Axle Shaft
18. C/V Joint Outer Race
Figure 45—Installing C/V Joint
Figure 46—Installing Seal Retaining Clamp
F-6725