Die-Cut Label - Toshiba B-SX600 SERIES Product Description

3. MEDIA AND RIBBON SPECIFICATIONS
3.2

DIE-CUT LABEL

"Die-cut label" refers to a label stock of which labels are die cut one by one and surroundings are removed,
as illustrated below.
When a die-cut label stock is loaded, either the Transmissive Media Edge Sensor or the Transmissive Media
Center Sensor is used to detect a print position. The Transmissive Media Center Sensor is located at the
centre of the label feed path. (Refer to section 1.3 of owner's Manual)
Precautions
･ The Transmissive Media Edge Sensor must be placed so that it does not come into contact with the media.
20 mm or less
Gap
2 to 13 mm
Transmissive Media
Edge Sensor
15 to 120 mm
25 mm
Media feed direction
R2 mm or less
3-2
EO13-33001
3.2 DIE-CUT LABEL
Label pitch
5 to 1,000 mm
Page start line