BenQ PH460 User Manual page 37

Control • RS-232C/LAN: Sets a terminal to control the display.
Setting
• IR Passthrough: Select it when multiple displays are connected via RS-232C
cables.
- Primary: Designate the display as the primary unit for remote control
- Secondary: Designate the display as the secondary unit. The display can
Network See
Settings
Assigns an ID number for the current display when multiple displays are
Set Monitor
connected.
ID
Uses the HDMI CEC (Consumer Electronics Control) industry standard
HDMI
protocol to share functionality between connected devices and the display. To
Control
transfer system commands, you need to use an HDMI cable to connect the
display to a device equipped with HDMI CEC. Select On in this menu and you
can operate the main functionalities on your display and the connected device
with one remote control.
operation. Only this display will be operated by the remote control.
not be operated by the remote control, and will only receive the control
signal from the primary display via the RS-232 connection.
To go back to the default setting (RS-232C) for Control Setting, press INFO on the
remote control for 5 seconds.
Network connection on page 27
For use when under the RS-232C control mode.
The OSD (On-Screen Display) menu
for details.
37