Network Connection; Connecting To A Lan; Controlling The Display - BenQ PH460 User Manual

Network connection

Connecting to a LAN

To set the display to connect to a local area network:
1. Connect a RJ45 cable to the corresponding ports on the display and your LAN
switch or router.
2. Enter the OSD menu Setting > Control Setting. Select LAN.
3. Enter the next OSD menu Setting > Network Settings.
If you are in a DHCP environment, select DHCP > Execute and press ENTER.
Once done, the IP Address, Subnet mask, Default gateway, Primary DNS,
and Secondary DNS settings will be displayed.
If you are not in a DHCP environment, select Manual > Execute and press
ENTER. Contact your ITS administrator for information on the IP Address,
Subnet mask, Default gateway, Primary DNS, and Secondary DNS settings
and enter it accordingly.
4. To save the settings and return to the previous menu, highlight Execute and press
ENTER on the remote control.

Controlling the display

Once you have the correct IP address for your display and the display is on or in standby
mode, you can use any computer that is on the same local area network to control the
display.
• You cannot control the display via the RS-232C connector when LAN control is in use.
• It is recommended that you use Internet Explorer versions 7.0 or higher browser.
1. Enter the IP address of the display in the address bar of your browser and press
Enter.
2. The setting page appears.
• Information: Shows information of the display. It is for information only. There are no
items that can be set.
• Picture & Sound: Provides options for picture and sound adjustments.
• Screen: Provides options related to display adjustments.
• Setting: Provides options for advanced display adjustments.
• Mail Report: Provides options for setting up email accounts to receive status or error
reports sent from the display.
• Network: Provides options for manually setting the display's IP address or obtaining an
IP address from a DHCP server.
Make sure the Setting > Control Setting menu is set to LAN, and the Setting > Power
Save menu is set to Low or Off if you would like to turn on the display from a web page.
Network connection 27