Adjustment And Confirmation Procedures - Integra DTR-8.4 Service Manual

QQ
3 7 63 1515 0

ADJUSTMENT AND CONFIRMATION PROCEDURES 1

Idling current adjustment
Before Idling current adjustment, turn the trimming resistors R6040 to R6046 to counter-clockwise.
Connect the DC voltmeter at the sockets P6080 to P6086.
After turn POWER to ON, adjust the trimming resistors R6040, R6041 and R6042 so that the reading of
voltmeter becomes 11 mV. (Front and center channels)
Adjust the trimming resistors R6043, R6044, R6045 and R6046 so that the reading of
voltmeter becomes 4.5 mV. (Surround and surround back channels)
After adjustment, attach the top cover.
Confirm the voltage of points above after about five minutes.
Front and center channels
When less than 16.5 mV, readjust the resistors above so that the voltage becomes 16.5 mV.
When 16.5 mV to 18.5 mV, you are not necessary to adjust.
When more than 18.5 mV, readjust the resistors above so that the voltage becomes 18.5 mV.
Surround and surround back channels
When less than 6.0 mV, readjust the resistors above so that the voltage becomes 6.0 mV.
When 6.0 mV to 8.0 mV, you are not necessary to adjust.
When more than 6.0 mV, readjust the resistors above so that the voltage becomes 8.0 mV.
Note: No load and No signal
TE
L 13942296513
Confirmation of protection circuit
1. Confirmation of operation of speaker relay
Confirm that the speaker relays turn ON approximate. 5 seconds after the power switch is turned ON.
Confirm that the speaker relays turn OFF immediately after the power switch is turned OFF.
2. Confirmation of DC detection circuit
Press and hold down CD button, then press STANDBY/ON and DISPLAY buttons to set the unit to
"Test " mode.
After "Test " on the FL tube light on, press VIDEO 1 button to set the unit to "Test-1-00".
Apply DC 1.5 to 3.5V to the MULTI-CH INPUT terminal with no load.
Confirm that the speaker relay turns OFF.
Apply DC -1.5 to -3.5 V to the MULTI-CH INPUT terminal with no load.
Confirm that the speaker relay turns OFF.
www
Caution: Don't apply DC voltage more than 1 sec..
.
http://www.xiaoyu163.com
R6040
P5004A P5004B
P6013 P6003
BIAS
ID+
ID+
ID-
ID-
R6044
R6043 P6084
P6083
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
P6081
P6080
R6041
ID-
ID-
ID+
ID+
Q Q
P6011
3 6 7 1 3 1 5
P5003B
P5003A
P6205
P6004 P5004C P5004D
P6005
P6015 P6016
BIAS
BIAS
ID+ ID+
ID-
ID-
P6085 R6045
P6086
co
.
78
9 4 2 8
R6042
ID-
ID+
P6012
0 5 8 2 9 9 4 2 8
P6002
P5003C
BIAS
R6046
NCAF-7706
m
DTR-8.4
9 9
9 9