Johannus Opus 5 User Manual page 28

6. Push SET when you selected the right channel (e.g. channel 7). The selected channel has
been assigned now to the MIDI stop.
The display will reflect the actual patch number directly after depressing (and releasing) the
SET piston.
7. Now you can choose the module voice you want to assign to the MIDI stop, by pressing once
or more times the minus or plus piston. The module voice (e.g. 41) will show up in the
display.
8. Push SET when you selected the right module voice (e.g. patch 41). To indicate that the
selected channel and module voice are being programmed a
as long as you push SET.
9. The MIDI stop MIDI Swell 2 now has been programmed with channel 7, module voice 41.
This means that recalling the concerning free combination the key data from the Swell is
transmitted through channel 7 to the external module while module voice (patch) 41 is
switched on.
10. Close the memory by turning the key switch MEMORY LOCK a quarter turn to the left and
eventually remove the key from the switch (not applicable on Opus 5 AGO). The light in the
SET piston will go off to indicate that the memory is not accessable anymore.
11. Switch off the PGM by pushing it again.
Using the capture system you can assign one MIDI-stop to serveral channels/module voice
(patches). E.g. an Opus 30 with expanded capture system may have 65 different settings per
MIDI stop. (1x manual setting, 32 general settings and 32 separate settings). The entire organ
can handle 4 x 65 = 260 different settings.
When programming more than one MIDI stop (with or without a combination with normal organ
voices) in one free combination you should start with the lowest numbered MIDI stop.
Program e.g. MIDI-Great 1, MIDI Swell 2 and MIDI Pedal 3 in one free combination as follows:
1. Switch on the three MIDI switches (upon wish including other organ stops).
2. First store this registration into the free combination of your choice. (see under 'Using free
combinations').
3. Push the PGM piston.
4. Choose the channel for MIDI Great 1 (the MIDI with the lowest number) by using the - and
+ pistons.
5. Push the SET piston.
6. Choose the module voice (patch) for MIDI Great 1 by using the - and + pistons.
7. Push the SET piston. The setting for MIDI Great 1 is programmed now.
8. Switch off the MIDI Great 1 stop.
9. Choose the channel for MIDI Swell 2 (now the MIDI with the lowest number) by using the -
and + pistons.
User's Manual
JOHANNUS JOHANNUS
23
P
will show up in the display
Opus 5, 10, 20 and 30 AGO