American Dynamics Illustra Flex series User Manual page 40

3.2.3.4 Firmware
System Information about Firmware Version, Mac Address, MCU Version, and Model Name are revealed
here as below figure. Users can update system firmware if available. All camera motions will shut down
during firmware update. Please close any other screens before firmware update. Never disconnect power or
LAN cable during the firmware update process. It takes approximately 3 minutes for the unit to reboot after
firmware update process. Please reboot the computer as well after firmware update process. Again, power
can't be lost when updating firmware since it will cause the update failure and manufacturer maintenance will
be required.
3.2.3.5 Configuration
Video Type
Select "NTSC" or "PAL" as required. Flickering by fluorescent light can be reduced by selecting "PAL" if the
power frequency is 50Hz, "NTSC", if 60Hz.
Import Configuration Settings
This function is designed to upload configuration setting from the client computer to the unit.
F 3-37: F
IGURE IRMWARE
F 3-38: F
IGURE IRMWARE
F 3-39: V
IGURE IDEO
F 3-40: I C
IGURE MPORT ONFIGURATION
40
Illustra Flex 1MP & 3MP Box Camera
U 1/2
PDATE
U 2/2
PDATE
T S
YPE ETTING
S
ETTING