Attaching An Optional Viewfinder - Sony HXC-D70 User Manual

Attaching an Optional Viewfinder

Attaching the DXF-20W viewfinder
1
1 Loosen the left-to-right positioning ring of the
camera, and 2 engage the slide rail on the backside
of the viewfinder with the viewfinder fitting shoe.
2
2
1 Slide the viewfinder in the direction shown by the
arrow to the required mounting position, 2 tighten
the left-to-right positioning ring of the camera, and 3
plug the viewfinder connector into the VF connector
(20-pin, round) of the camera, and clip the cable into
the cable clamp.
VF connector (20-pin, round)
Stopper
Slide rail
Viewfinder fitting
shoe
1
Left-to-right
positioning ring
1
2
3
Cable clamp
Viewfinder connector
Notes
• Be sure to power off the camera before plugging the
viewfinder connector into the VF connector on the camera.
If the connector is plugged in while the power is on, the
viewfinder may not operate correctly.
• Make sure that the viewfinder connector is pushed fully into
the VF connector (20-pin, round) on the camera. If the
connector is not firmly connected, the image may break up,
or the tally light may not operate properly.
To detach the DXF-20W viewfinder
To detach the viewfinder from the camera, conduct the
attachment procedure in reverse. When removing the
viewfinder from the camera, pull up the stopper.
Attaching the DXF-801 viewfinder
Replace the viewfinder fitting shoe, following the steps below
before attaching the DXF-801 viewfinder.
Note
The following accessories are not supplied with the HXC-
D70K/D70L. (A 3.5-type color LCD viewfinder is supplied with
the HXC-D70K/D70L.)
– Viewfinder fitting shoe (service part number: 3-776-885-
03)
– Hexagonal wrench (size: 2.5 mm) (service part number: 7-
700-736-04, 7-721-130-53)
1
With the supplied hexagonal wrench (size: 2.5 mm),
remove the bolts and spring washers, and detach the
viewfinder fitting shoe from the VF shoe fixing
bracket.
2
Loosen the viewfinder left-to-right positioning ring
and detach it from the viewfinder fitting shoe.
3
Attach the ring to the supplied viewfinder fitting shoe
and tighten the ring.
Positioning ring
VF shoe fixing bracket
Left-to-right positioning ring
Viewfinder fitting
shoe
DXF-801 viewfinder fitting shoe
Attaching the Viewfinder
27