Op X/Z, X1/Z1,X2/Z2 Mode - Sharp ER-A440 Programming Manual

CHAPTER 3. OP X/Z, X1/Z1,X2/Z2
MODE
The following categories of reports can be printed by the ECR.
OP X/Z reports: These reports are taken by operators in order to
report their own sales data.
XI/Z1 reports: These reports are taken by the supervisor or man-
ager in order to check and report daily sales totals
at that point.
X2/Z2 reports: These reports are taken by the owner or manager
in order to check and report periodic (weekly or
monthly) tatals.
MGR/Flash-read: These reports are taken by the owner or manager
in order to check and display daily sales totals at
that point.
To print reports, use the following key entry sequence
Reading
JOB# @/FOR
Resetting
REPORT NAME
GENERAL
DEPT/GROUP
IND. GROUP
GROUP TOTAL
PLU BY RANGE
PLU BY DEPT
PLU ZERO SALES
PLU PRICE CATEGORY
TRANSACTION
CID
ALL CASHIER
IND. CASHIER
HOURLY (ALL)
HOURLY (RANGE)
DAILY NET
STACKED REP
1 X1: Daily X report
X2: Periodic X report
Stop of printing reports:
The printing of all reports can be stopped by the following operation.
Set the mode switch to "MRG" to cancel.
Note) When the printing is stopped, the consecutive number or Z
counter don't return to the original value.
When Z reports, Memory is not reset.
1 X1: Daily X report
X2: Periodic X report
2 The time interval range, PLU code range can be specified by
entering the start and end numbers according to the following
procedure. When specifying a single time interval, PLU code,
the start number has only to be entered.
XXXXXX
Start No.
CA/AT
Range is required
OP X/Z X1/Z1
X Z X1
Z1: Daily Z report
Z2: Periodic Z report
Z1: Daily Z report
Z2: Periodic Z report
All
@/FOR
XXXXXX
End No.
MODE 1
X2/Z2 F-read
Z1 X2 Z2 X1 4
3 When 2 is entered in the third digit of a job code, periodic reports
are printed.
Example: Daily general report; job code 100
*4 Reading display only
→
(Display amount) (Display initialize)
KEY
– 36 –
3 DATA FOR
JOB# READING
00 —
10 —
12 GROUP No.
13 —
20 PLU CODE
21 DPT CODE
27 ALL
29 PRICE
30 —
31 —
50 —
51 —
60 —
60 TIME
70 —
90 —
Periodic general report; job code 200
→
KEY CL
DEPT = DEPTn key
CID = @/For key
Daily Net = ST key
NOTE
2
2
ALL CASHIER
2