Control Panel; System Cooling - Supero SuperServer 1027GR-TRFT series User Manual

S S
UPER ERVER 1027GR-TRF/1027GR-TRFT Series User's Manual
Figure 6-1. Chassis: Front and Rear Views
GPU Card
Power Supplies
Note: the number of PCI slots available depends on the presence of GPUs in the
server model.
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Installation."
6-3

System Cooling

Ten 4-cm counter-rotating fans provide the cooling for the system. Each fan unit
is actually made up of two fans joined back-to-back, which rotate in opposite di-
rections. This counter-rotating action generates exceptional airfl ow and works to
dampen vibration levels.
It is very important that the chassis top cover is properly installed and making a
good seal in order for the cooling air to circulate properly through the chassis and
cool the components.
Control Panel
Hot-Swap Drive Bays (4)
PCI Slot
Rear I/O Ports
6-2
GPU Card
GPU Card