Table of Contents
Advertisement
BMC Enable/Disable
Use jumper JPB1 to enable or disable the
BMC (Baseboard Management Controller),
which supports IPMI 2.0/KVM. See the
table on the right for jumper settings.
5-10 Onboard Indicators
LAN1/2 Port LEDs
The Ethernet ports have two LEDs. On
each port, one LED indicates activity while
the other LED may be green, amber or
off to indicate the speed of the connec-
tion. See the table on the right for the
functions associated with the connection
speed LED.
Note: the dedicated IPMI LAN does not
operate at 1 Gb/s.
Dedicated IPMI LAN Port LEDs
A dedicated IPMI LAN port is also located
on the I/O backplane. The amber LED on
the right indicates activity, while the green
LED on the left indicates the speed of the
connection. Please note that the IPMI LAN
does not support 1Gbps connections. See
the table at right for more information.
Onboard Power LED
An Onboard Power LED is located at
LE1. This LED Indicator is on when the
system is on. Be sure to unplug the AC
power cable before removing or adding any
components. See the table on the right for
more details.
Chapter 5: Advanced Serverboard Setup
BMC Enable/Disable
Jumper Settings
Both Jumpers
Pins 1-2
Pins 2-3
LAN Port LEDs
(Connection Speed Indicator)
LED Color
1 Gb Ports
Off
NC or 10 Mb/s
Green
100 Mb/s
Amber
1 Gb/s
IPMI LAN LEDs
Color/State
Link (Left)
Green: Solid
Activity (Right)
Amber: Blinking
Onboard PWR LED Indicator
LED Color
Defi nition
Off
System Off (power cable
not connected)
Green
System On
Green:
ACPI S1 State
Flashing
Quickly
5-23
Defi nition
Enabled
Disabled
10 Gb Ports
10/100 Mb/Off
10 Gb/s
1 Gb/s
Defi nition
100 Mbps
Active
Advertisement
Table of Contents
