Table of Contents
Advertisement
5-6
Installing Memory
CAUTION! Exercise extreme care when installing or removing DIMM
!
modules to prevent any possible damage.
Memory Support
The X9DRG-HF/X9DRG-HTF supports up to 256 GB of registered ECC DDR3-
1600/1333/1066/800 MHz RDIMMs in 8 DIMM slots. See the following tables for
memory installation.
Notes: Memory speed support is dependent on the type of CPU used on the board.
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMM 1A. For best memory performance, please install memory modules
of the same type and same speed on the memory slots as indicated on the
tables below.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-4).
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules.
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Chapter 5: Advanced Serverboard Setup
Figure 5-3. DIMM Installation
Notch
Release Tab
Top View of DDR3 Slot
5-9
Front View
Note: Notch should align
with the receptive key
point on the slot.
Release Tab
Notch
Advertisement
Table of Contents
