Table of Contents
Advertisement
2.
How to operate
2.1
General Information
You can operate all functions of the system by use of the 18 buttons on the front of the unit. Additionally,
you can remotely control this unit via the Ethernet port located on the back side.
The system status is indicated by either with the LED light on the operator buttons or on the monitor.
The system does not record when it is in SETUP mode or REPLAY mode.
The system has the following 4 operating modes;
1. LIVE Mode
3. REPLAY Mode
2.2
Configuration of the front panel of the unit
1
1) Removable HDD Rack
2) Ch1 (Channel Selection)
3) Ch2 (Channel Selection)
4) Ch3 (Channel Selection)
5) Ch4 (Channel Selection)
6) QUAD (Quad selection) / SEQ (Sequential Display)
7) FREEZE (Freeze)
8) OSD (OSD On/Off)
9) TALK** (Talk to specific camera)
10) REC LED (Recording Status Display LED)
11) PLAY LED (Playback Status Display LED)
2. RECORD Mode
4. SETUP Mode
2
3
17
18
[Fig. 2-1 Configuration of the front panel of the unit]
15) POWER LED (Power Status Display LED)
16) Monitor Power Switch
17) REC (Recording)
18) PLAY
19) STOP/ESC (Play Stop or Escape)
20) SETUP/ENTER (System setup mode / Execution)
21) REW/LEFT (Rewinding / Navigation)
22) PAUSE/RIGHT (Reverse Playback Pause / Navigation)
23) PAUSE/DOWN (Playback Pause / Navigation)
24) FF/UP (Fast Forward / Navigation)
25) JOG SHUTTLE
- 6 -
10
4
5
6
7
8
9
19
21
23
20
22
24
11
13
15
12
14
16
26
27
25
Advertisement
Table of Contents
