Advertisement
V . C O M F O R T A D J U S T M E N T S
WARNING! The positioning belt is not
designed for use as a seat belt in a
motor vehicle. Nor is your PMV
suitable for use as a seat in any
vehicle. Anyone traveling in a vehicle
should be properly belted into seats
approved
manufacturer.
WARNING!
should be secured at all times. Never
allow the positioning belt to hang or
drag on the floor as it may become
entangled.
To install the positioning belt (if required):
1. Remove the seat from your PMV.
2. Place the seat upside down so that you can see the
bottom of the seat base. See figure 17.
3. Use a wrench to remove the two rear bolts that
attach the seat frame to the seat base.
4. Insert the bolt through the appropriate ends of the
positioning belt and then reinstall the bolts and
belt back into the seat bottom.
5. Tighten the bolts.
Metal tab style positioning belt
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt into the plastic housing on the opposite strap until you
hear a "click." See figure 18.
2. Pull the strap on the right side of the belt until it is secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
Reusable hook and loop fastener style positioning belt
To adjust the positioning belt for operator comfort:
1. Align the two sides of the belt placing the looped-end side directly above the coarser side ("hook") of
the opposite belt. Press firmly together to fasten. See figure 18.
To release the positioning belt:
1. Grasp the looped-end side of the belt and pull up to detach from the other side of the belt.
MANDATORY! Make sure the positioning belt is properly secured to the PMV and is
adjusted for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose parts or damage, including tears,
worn spots, bent hardware, or damaged latch mechanisms, dirt or debris, before each
use of the PMV. If you discover a problem, contact your authorized Provider for
maintenance and repair.
26
by
the
vehicle
The
positioning
belt
Figure 18. Positioning Belt–Metal Tab Style or Reusable
Hook and Loop Fastener Style
OR
PMV Series
Advertisement
