Advertisement
I I I . B A T T E R I E S A N D C H A R G I N G
4. Disconnect the battery cables from the battery
terminals by sliding back the terminal boots and
unscrewing the nut from the bolt. See figure 13.
5. Remove the old batteries from the battery wells.
6. Place a new battery in each battery well according to
the battery wiring diagram as shown in figure 12.
NOTE: Use battery straps to secure batteries in the bat-
tery wells. Please refer to figure 14 for battery strap
installation procedures.
7. Connect the red battery cable to the positive (+)
battery terminal on each battery.
8. Connect the black battery cable to the negative (-)
battery terminal on each battery.
9. Reposition the terminal boots over the battery
terminals.
10. Reconnect the battery tie-down straps.
11. Reinstall the battery shroud, the rear shroud, and the
seat.
NOTE: If you encounter a damaged or cracked battery,
immediately enclose it in a plastic bag. Contact your
local waste disposal agency or your authorized Provider
for instructions on disposal and battery recycling,
which is our recommended course of action.
20
IDENTIFICATION KEY
1. MAIN CIRCUIT BREAKER
2. BATTERY TERMINALS UNDER BOOTS
3. BATTERY TIE-DOWN STRAPS
2
3
2
1
Figure 12. Battery Removal/Installation Terminals
and Connections
Figure 13. Battery Terminal Hardware
2
3
2
PMV Series
Advertisement
