Toshiba RAV-SP560AT-E Service Manual page 172

Toshiban lämmitys- ja jäähdytyslaitteiden jälleenmyyjä pääkaupunkiseudulla on Jäähdytinpalvelu RefGroup Oy
No. Part name
†
1. Detachment
Fan motor
1) Perform works of items 1 of
2) Remove clamps of the lead wires con-
NOTE :
Remove the connector by releasing locking
of the housing.
3) Remove screws fixing earth lead wire in
4) Remove indoor/outdoor inter-unit cable
5) Remove screws fixing the electric parts
6) Remove screws fixing the bell mouth.
7) Remove nuts fixing the turbo fan.
8) Remove screws fixing holder of the motor
9) Remove nuts fixing the fan motor to
2. Attachment
1) Fix the parts, fan motor, holder of the
NOTE 1 :
When fixing the turbo fan, be sure to match
the fan boss with D-cut of the motor shaft.
NOTE 2 :
Fix the turbo fan with torque wrench
5.9 ± 0.6Nm.
2) Connect connectors, earth lead wire,
Procedure
‚
.
nected to the following connectors of the
control P .C. board.
CN33 : Flap motor (5P: White)
CN34 : Float switch (3P: Red)
CN68 : Drain pump (3P: Blue)
CN101 : TC sensor (2P: Black)
CN102 : TCJ sensor (2P: Red)
CN333 : Power supply of fan motor
(5P: White)
CN334 : Position detection of fan motor
(5P: White)
the electric parts box. (Ø4 x 6, 2 pcs.)
and remote controller cable of the termi-
nal block.
box. (Ø4 x 10, 5 pcs.)
(Ø4 x 10, 6 pcs.)
(M6, 1 pc.)
lead wires to remove the motor lead wires
from the clamp. (Ø4 x 8, 3 pcs.)
remove it.
motor lead, turbo fan, bell mouth, and
electric parts box successively to their
original positions.
indoor/outdoor inter-unit cable, and
remote controller cable which have been
disconnected in the above item 1 as
before.
– 172 –
www.ilmalämpöpumput.com
RAV-SM560/800/1100/1400UT-E
RAV-SP1100UT-E

and 1 of
Screws fixing electric parts box
Remarks
Screws fixing earth lead wires
Bell mouth
Turbo fan
Motor lead holder
Fan motor