Miele G 7836 CD Operating Instructions Manual page 57

– Large surface area filters are
enclosed in the kit supplied with the
machine for installing between the
stopcock and the inlet hose (see
illustration in Problem solving -
"Cleaning the filters in the water
inlet"). The large surface area filter is
made from chrome nickel steel and
can be recognised by the matt top
surface.
,
The inlet hoses must not be
shortened or damaged in any way
(see illustration).
See also the installation diagram
supplied.
AD water connection (pressurised)
ö 0.6 - 10 bar (60 - 1000 kPa) over
pressure
The machine is supplied as standard
for connection to an AD water supply of
0.6 - 10 bar (60 - 1000 kPa). If the water
pressure (flow rate) is below 1.5 bar
(150 kPa) the water intake time is
automatically extended.
^ The AD pressure tested hose
(marked "H O pur") with a 3/4"
2
threaded union must be connected to
the on-site AD stopcock for purified
water.
,
Note: If the machine is not going
to be connected to an AD water
supply, the cleaning and disinfecting
programmes will have to be altered
by a Miele Service technician.
The inlet hose will remain on the rear
of the machine.
Optional AD water connection
(without pressure) 0.085 - 0.6 bar (8.5
- 60 kPa)
The appliance must be converted
(special accessory) (if this has not
already been done at the factory)
before connecting to a water supply
0.085 - 0.6 bar (8.5 - 60 kPa). The feed
pump must be fitted by a Miele service
technician only.
When connecting an AD water
container (without pressure) the drain
connection must be at least the height
of the upper edge of the machine (see
"Installation instructions").
Plumbing
57