Adjustment Of Auto-Toner Sensor - Toshiba e-STUDIO203 Service Handbook

3. ADJUSTMENT
3.1

Adjustment of Auto-Toner Sensor

When the developer material is replaced, adjust the auto-toner sensor in the following procedure.
<Procedure> (Adjustment Mode (05-200))
(1) Install the process unit into the equipment.
Note: Note:
Do not install the toner cartridge.
(2) While pressing [0] and [5] simultaneously, turn the power ON.
The following message is displayed on a 7-segment LED.
(3) Key in code [200] and press the [START] button.
The display on the 7-segment LED changes as follows and the "density LEDs" lights from the left
in order.
[2][0][0]
December 2005 © TOSHIBA TEC
[0][5]
[POWER]
Fig. 3-1
[START]
Fig. 3-2
3 - 1
e-STUDIO163/203 ADJUSTMENT
3