Cover Open Jam - Toshiba e-STUDIO203 Service Handbook

Hide thumbs Also See for e-STUDIO203:
Table of Contents

Advertisement

5.1.3

Cover open jam

[E40]
ADU cover opened during printing
Is the ADU cover open?
YES Æ Remove paper if there is any, then close the cover.
È
NO
Is the voltage of 24V being supplied from the power supply unit?
(Perform the input check in the test mode: 03-[INTERRUPT]OFF/[8]/[6])
NO Æ
l
l
l
l
l
l
l
È
YES
Replace the MAIN board.
December 2005 © TOSHIBA TEC
1) Check if the connector for 24 V power supply is disconnected.
2) Check if the connector CN23 on the MAIN board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the MAIN board is short circuited or
open circuited.
5) Replace the MAIN board.
5 - 7
e-STUDIO163/203 TROUBLESHOOTING
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-studio163

Table of Contents