Highavailability - D-Link DFL-260E Reference Manual

3.20. HighAvailability

3.20. HighAvailability
Description
Configure the High Availability cluster parameters for this system.
Properties
Enabled
ClusterID
SyncIface
NodeID
HASyncBufSize
HASyncMaxPktBurst
HAInitialSilence
UseUniqueSharedMac
HADeactivateBeforeReconf
ReconfFailoverTime
HAFailoverTime
Note
This object type does not have an identifier and is identified by the name of the type
only. There can only be one instance of this type.
Enable high availability. (Default: No)
A (locally) unique cluster ID to use in identifying this group
of HA security gateways. (Default: 0)
Specifies the interface used for state synchronization.
Master or Slave. (Default: Master)
How much sync data, in KB, to buffer while waiting for ac-
knowledgments from the cluster peer. (Default: 1024)
The maximum number of state sync packets to send in a
burst. (Default: 20)
The number of seconds to stay silent on startup or after recon-
figuration. (Default: 5)
Use a unique shared mac address for each interface. (Default:
Yes)
Deactivate(hand over) before Reconfiguration if Active.
(Default: Yes)
Number of non-responsive seconds before failover at HA re-
conf (0=immediate failover). (Default: 0)
Number of milliseconds before failover when active HA node
becomes non-responsive. (Default: 750)
120
Chapter 3. Configuration Reference