KitchenAid KBMS1454R Technical Education page 20

27" (68.6 cm) or 30" (76.2 cm) Installation
1. Hold Z-brackets against the outside edges
of cutout opening, and mark holes. Make
sure bottom ends of brackets rest on the
cutout floor, as shown.
A
B
C
A. Cutout opening
B. Z-brackets (2)
C. 1/2" T-10 screws (4)
2. Drill holes into the inside edges of cutout
opening using 5/64" (2 mm) drill bit.
3. Attach Z-brackets to side edges of cutout
opening using four 1/2" T-10 screws.
4. With the microwave oven near the open-
ing, plug the microwave oven into the
grounded 3-prong outlet.
5. Slide microwave oven all the way into the
opening.
NOTE: The flat portion of the side brackets
should slide over the tops of the Z-brackets,
and the vertical portion of the side brackets
should rest against the front surface of the
recessed portion of the Z-bracket.
A. Side bracket
B. 3/8" T-10 screw
C. Z-bracket
2-6
A
B
C