Mounting On A Standard Or Versatools Rack Shelf - Extron electronics YCS SW2 A User Manual

Installation and Operation, cont'd
5. Reliable earthing (grounding) — Maintain reliable
grounding of rack-mounted equipment. Pay particular
attention to supply connections other than direct
connections to the branch circuit (e.g., use of power strips).

Mounting on a standard or VersaTools rack shelf

1. If feet were previously attached to the bottom of the YCS,
remove them.
QuarterRackVersaToolsShelf1inchBox
2. Mount the YCS SW2 A on the rack shelf, using two 4-40 x
3/16" screws in opposite (diagonal) corners to secure the
unit to the shelf (see figure 2-1, below).
3. Install blank panel(s) or other unit(s) on the rack shelf as
desired.
The following illustrations show examples of how the YCS can
be mounted on the three different sized rack shelves.
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
Use 2 mounting holes on
opposite corners.
Figure 2-1 — Mounting a YCS SW2 A (with other
units) on a VersaTools rack shelf
2-4 YCS SW2 A • Installation and Operation
(2) 4-40 x 3/16"
Screws
QuarterRackStandardShelf
1U Universal Rack Shelf
1/2 Rack Width Front False
Faceplate
Both front false faceplates
use 2 screws.
Use 2 mounting holes on
opposite corners.
Figure 2-2 — Mounting a YCS SW2 A on a 9.5-inch
deep rack shelf
6" Deep Rack Shelf 1/2 Rack Width Front False
Faceplate
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Figure 2-3 — Mounting a YCS on a 6-inch deep rack
shelf
YCS SW2 A • Installation and Operation
1/4 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
(2) 4-40 x 3/16"
Screws
2-5