SECTION 5—WHEELCHAIR OPERATION
Repositioning the Joystick
NOTE: For this procedure, refer to FIGURE 5.10.
1. Turn the adjustment lock lever to
release the joystick mounting tube from
the mounting bracket.
2. Remove the joystick from the wheelchair.
3. Remove the three hex screws that
secure both halves of the mounting
bracket to the arm tube.
4. Reposition mounting bracket on
opposite arm tube ensuring the
threaded plate of the mounting bracket
is on the inside of the arm tube as
shown in FIGURE 5.10.
5. Using the three hex mounting screws and washers, secure both halves of the mounting
bracket to the arm tube.
6. Slide the joystick mounting tube through the mounting bracket to the desired position.
7. Turn the adjustment lock lever to secure the joystick mounting tube into the mounting
bracket.
TDX™ Wheelchairs
Washers
Mounting
Hex
Bracket
Mounting
Screws
Adjustment
Lock Lever
FIGURE 5.10 Repositioning the Joystick
48
Mounting Bracket
(Threaded Plate)
Arm
Tube
NOTE:
Joystick
not
Joystick
shown.
Mounting
Tube
Part No 1143150