Assembling The Motor In The Router Base; Adjusting Depth Of Cut - Porter-Cable 690 Instruction Manual

899749 - 11-30-01.qxd 2/12/02

ASSEMBLING THE MOTOR IN THE ROUTER BASE

1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2. Loosen the clamp screw (A) Fig. 1 to allow the power unit to be set in the
base unit.
3. Insert motor unit into base aligning lower pin (B) with groove in base.
4. Rotate motor unit CLOCKWISE into base until upper guide pins are
rigidly set in the groove of the base.
5. Tighten clamp screw firmly.

ADJUSTING DEPTH OF CUT

1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2. Loosen clamp screw (A), Fig. 3.
3. While holding base (E), turn motor unit (F), Fig. 3, COUNTERCLOCK-
WISE until the tip of the bit is above bottom surface of base.
4. Set router on flat wood surface.
5. Turn motor unit (F), Fig. 3, CLOCKWISE until bit touches the wood
surface.
6. Tighten clamp screw (A), Fig. 3.
7. Rotate depth adjusting ring (B), Fig. 3, until the zero-line (C) is opposite
the index line (D) on the housing.
8. Loosen clamp screw (A), Fig. 3.
D
C
A
2:24 PM Page 7
Fig. 2
Fig. 3
7
F
B
E