Porter-Cable 690 Instruction Manual page 4

899749 - 11-30-01.qxd 2/12/02
2. NEVER ADJUST depth of cut while motor is running. A slip at this time
may cause personal injury, or damage to cutter or workpiece.
3. BE SURE cord is free and will not "hang up" during routing operations.
4. KEEP HANDS CLEAR of cutter when motor is running to prevent
personal injury.
5. MAINTAIN FIRM GRIP on router when starting motor to resist starting
torque.
6. STAY ALERT and keep cutter clear of all foreign objects while motor is
running.
7. BE SURE motor has completely stopped before setting machine down
between operations.
8. DO NOT use router bits with a diameter in excess of 2
machine.
9. DO NOT use router hand-held in an upside-down or a horizontal
position. Motor can fall from base if not properly attached according to
instructions.
10. AVOID "CLIMB-CUTTING". "Climb-cutting" increases the chance for
loss of control resulting in possible personal injury.
11. NEVER TOUCH router bits after use, as they may be extremely hot.
12. BE SURE bit is centered in templet guide prior to templet guide
applications to avoid personal injury or damage to finished work.
13. DO NOT USE ROUTER MOTOR without the router base installed, loss
of control could result, causing personal injury or damage to work.
14. SOME WOOD CONTAINS PRESERVATIVES WHICH CAN BE TOXIC.
Take extra care to prevent inhalation and skin contact when working with
these materials. Request, and follow, any safety information available from
your material supplier.
15. WARNING: There are certain applications for which this tool was
designed. Porter-Cable strongly recommends that this tool NOT be modified
and/or used for any application other than for which it was designed. If you
have any questions relative to its application DO NOT use the tool until you
have written Porter-Cable and we have advised you.
SYMBOL
V ........................ volts
A ........................ amperes
Hz ........................ hertz
W ........................ watts
kW ........................ kilowatts
µF ........................ microfarads
l ........................ liters
kg ........................ kilograms
N/cm 2 ........................ newtons per square centimeter
Pa ........................ pascals
h ........................ hours
min ........................ minutes
s ........................ seconds
2:24 PM Page 4
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
Jackson, TN 38305
DEFINITION
4
1 " in this
/
8