Replacing Drawer Seal; Lower Oven Chassis - Electrolux EW30DF65GB Service Manual

Electrolux ew30df65g and cewdf65g series freestanding dual fuel range

Hide thumbs Also See for EW30DF65GB:

Use and care manual (64 pages)

Table Of Contents

Table of Contents

The rubber drawer seal is secured to the drawer liner by metal

spring clips that are integral to the seal. To remove the seal grasp

securely at the clip and pull away from the liner. Replace by

positioning the point of the clip into the hole and pressing in until

the clip locks into place.

The lower oven chassis can be removed as

an entire assembly. Begin by removing the

temperature probe harness cover plate as

described on page 38.

Unplug the lower oven temperature probe harness

connector and the lower oven wiring harness

connector. (Photo A)

Remove the drawer per instructions on page 37.

Using a ¼" nut driver with magnetic screw holder

remove the two screws securing the lower oven

chassis to the range chassis.

These screws are accessed through the holes in

the lower oven cavity liner just below the drawer

glide rail. (Photo B).

The lower oven chassis can now be pulled

forward and removed from the range. (Photo C).

With the lower oven chassis removed the

insulation and chassis panels can be serviced.

NOTE: The lower oven chassis is not available

as a complete replacement assembly.