Replacing Lower oven thermal Cutout
The lower oven thermal cutout is located behind the
Photo A
access cover plate located at the lower portion of the
Cover Plate
chassis near the center of the range when viewed
Mounting Screws
from behind. (Photo A)
Take out the four cover plate mounting screws and
Photo B
remove the cover.
Once the cover plate is removed the lower oven
thermal cutout and harness connections are
Thermal Cutout
accessible. (Photo B)
Mounting Screws
To remove the cutout, unplug the harness
connections and remove the two mounting screws.
Replacing Drawer Glide Rails
The lower oven drawer glide rails (Fig. 1) clip into
Fig. 1
the side wall of the lower oven cavity and are se-
cured by one screw in each rail.
The mounting screw is accessed through a hole in
Fig. 2
the glide rail outer track. (Fig. 2) .
Remove
Screw
Once the mounting screw is removed extend the outer track of the glide rail until it stops. Pull forward
firmly until the hooks on the back of the rail disengage from the slots in the oven cavity side wall.
( Fig. 3 & 4 )
Fig. 3
Fig. 4
Slots
Pull Forward
Glide Rail Hooks
Page 39