Installing The Ink Cartridges; Filling With Ink For The First Time - Roland SOLJET PRO4 XF-640 Setup Manual

5. Installing the Ink Cartridges

Filling with Ink for the First Time

Special procedures are required when installing ink cartridges for the first time. These are required only once,
when installing ink cartridges for the first time after shipment from the factory. Firstly, clean the print heads
with the cleaning cartridges, and then fill with the inks of each color. This operation requires two UNUSED SOL
INK cleaning cartridges and 6 dummy cartridges.
* For SOL INK cleaning cartridges and ink cartridges, be sure to use new ones.
* Never, under any circumstances, use anything other than the specified type of ink or cleaning liquid.
Installing the Ink Cartridges
Be sure to follow the on-screen instructions for insertion and removal.
Insert in the direction shown in the figure.

Insert and remove slowly, one at a time.

Insert firmly, as far as it will go.

During cleaning, you need to insert and remove cartridges several times. The on-screen messages tell you when or
which cartridge to be inserted or removed. The SOL INK cleaning cartridges are not differentiated by color.
Insert each color ink cartridge into the slot labeled with the matching color. If you insert wrong car-
tridges when filling ink, the condition cannot be restored easily. Contact your authorized Roland DG
Corp. dealer, if you filled ink with wrong cartridges inserted.
CAUTION
32
Never insert your hand or fingers into the opening of the front cover.
The print heads move at high speed inside the cover. Hitting may cause injury.
YE
Slot number
YE YE CY CY
2
1 3 4