Table of Contents
Advertisement
Information provided by the Tour Status is dynamically updated as the tour progresses:-
1.
Progress - shows how far through the tour you are. On the right hand side of this control are
two buttons that allow you to step forward or backward.
2.
Speed - actual instantaneous speed.
3.
Altitude - instantaneous altitude.
4.
Date/Time - instantaneous Date and Time. If this data is incorrect it may be due to an
incorrectly set time-zone. See Settings->Set Time Zone on the analyser screen.
The display will automatically zoom down to the location on the globe where the route was recorded.
Uphill sections are shown in red and downhill in green.
Navigation controls
1.
Click and drag the left mouse button to pan the visible image.
2.
Double left clip to zoom on a point.
3.
Click and drag the right mouse button to control rotation and zoom.
4.
Double right click to zoom out.
5.
Left shift + left mouse button control rotation and tilt angle
The options section control visible data such as the status bar and navigation controls.
The Layers section control visible layers such as Terrain (3D), Buildings (3D), roads and borders but
the Look At or Camera requires a bit of an explanation (see below).
Whenever the tour is not running clicking the Take Picture button with record a snap shot of the
image and save it to your hard disk.
To start the tour:-
1.
First select your chosen model from the list, be it a skier, a border, a car or a bike.
2.
Click Reset Tour, this will reset all the internal systems and zoom down to the start point of
the loaded data. Your selected model will also now be visible. If it's not the right one just
© GTrek Ltd. 2013
Page 45 of 62
Version 5.4.0
Advertisement
Table of Contents
