Heating Elements (Electric Models) - Henny Penny 500 Technical Manual

2-8. HEATING ELEMENTS
(ELECTRIC MODELS)
(Continued)
305
10. Replace the brass nuts (4) and washers (3) on the
heating element terminals. Tighten the brass nuts to
30 foot lbs of torque.
11. Move the element spreaders from the center of the
element, into a position which will spread each element
apart evenly on all four sides, and tighten.
12. Replace the high limit bulb holder on the top element,
and position the bulb between the top and second element
midway from side to side, and tighten screw which holds
the bulb in place.
13. Reconnect the wires to the appropriate terminal as
labeled when they were removed.
14. Replace the front control panel.
15. Connect the power cord to the wall receptacle or close
wall circuit breaker.
Heating elements should never be energized without
shortening in the frypot, or damage to elements could
result.
16. Check the heating elements as described in paragraph 2-17 of
Operator's Manual.
17. Replace the shortening in the frypot.
Model 500/600
2-11