Audiovox Rampage AA-939 Installation Manual
  1. Manuals
  2. Brands
  3. Audiovox Manuals
  4. Car Alarm
  5. Rampage AA-939
  6. Installation manual
Audiovox Rampage AA-939 Installation Manual

Audiovox Rampage AA-939 Installation Manual

Remote control auto security system with starter interrupt, parking light flash and built in 2 stage shock sensor
Hide thumbs
Table of Contents

Advertisement

Quick Links

Model/Modèle/Modelo AA-939
REMOTE CONTROL AUTO SECURITY SYSTEM WITH STARTER INTERRUPT,
PARKING LIGHT FLASH AND BUILT IN 2 STAGE SHOCK SENSOR
SYSTÈME ANTIVOL À TÉLÉCOMMANDE AVEC BLOCAGE DU DÉMARREUR, CLIGNOTEMENT
DES FEUX DE POSITION ET DÉTECTEUR D'IMPACT À 2 NIVEAUX INTÉGRÉ
SISTEMA DE SEGURIDAD PARA AUTOMÓVILES A CONTROL REMOTO, CON
DESACTIVACIÓN DEL ARRANCADOR, DESTELLO DE LUCES DE ESTACIONAMIENTO
Y DETECTOR DE CHOQUE INCORPORADO DE 2 ETAPAS
INSTALLATION GUIDE & OWNER'S MANUAL
GUIDE D'INSTALLATION ET MANUEL D'UTILISATION
GUÍA DE INSTALACIÓN Y MANUAL DEL USUARIO
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions;
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Ce dispositif est conforme à la partie 15 du Règlement de la FCC. L'utilisation est soumise aux deux conditions suivantes :
(1) Ce dispositif ne doit pas émettre de brouillage nuisible et (2) il doit accepter toute interférence reçue, y compris celles
susceptibles de provoquer un fonctionnement indésirable.
Este dispositivo cumple con la parte 15 de las reglas de la FCC. El funcionamiento está sujeto a las dos siguientes condiciones:
(1) este dispositivo no puede causar interferencias nocivas, y (2) este dispositivo debe aceptar cualquier interferencia que reciba,
incluyendo aquellas que puedan llegar a causar un funcionamiento no deseado.

Advertisement

Table of Contents
loading

Related Manuals for Audiovox Rampage AA-939

Summary of Contents for Audiovox Rampage AA-939

  • Page 1 Model/Modèle/Modelo AA-939 REMOTE CONTROL AUTO SECURITY SYSTEM WITH STARTER INTERRUPT, PARKING LIGHT FLASH AND BUILT IN 2 STAGE SHOCK SENSOR SYSTÈME ANTIVOL À TÉLÉCOMMANDE AVEC BLOCAGE DU DÉMARREUR, CLIGNOTEMENT DES FEUX DE POSITION ET DÉTECTEUR D'IMPACT À 2 NIVEAUX INTÉGRÉ SISTEMA DE SEGURIDAD PARA AUTOMÓVILES A CONTROL REMOTO, CON DESACTIVACIÓN DEL ARRANCADOR, DESTELLO DE LUCES DE ESTACIONAMIENTO Y DETECTOR DE CHOQUE INCORPORADO DE 2 ETAPAS...

  • Page 2: Mounting The Siren

    CONGRATULATIONS On the purchase of your new Audiovox Alarm System. Taking a few minutes to read this installation and owners guide will provide you with the detailed information concerning all the features of your new alarm system. MOUNTING THE SIREN: 1.

  • Page 3: Wiring The System

    If you have any questions with the wiring procedures, please call a qualified automotive technician, or call the AUDIOVOX HOT LINE at 1-800-225-6074. Prior to making any connections, a 12 Volt logic probe should be used to confirm the proper connection point.
  • Page 4 YELLOW wire will be routed toward the fuse panel. Caution should be used when routing wires. Keep wires away from all hot surfaces, and any moving parts of the vehicle (radiator fans, accelerator or brake pedal linkage, etc.). When routing wires through the firewall, be sure to pass the wires through an existing rubber grommet.
  • Page 5 Connection Method B; A. “Fuse clip” terminals, which will plug in with the contacts of the fuse, are available at most electronics stores. This method of connection may be easier in some vehicles. B. Refer to the specific instructions included with the fuse clip terminals.
  • Page 6 PROGRAMMING THE TRANSMITTERS: Your AA-939 Security System can program up to two Audiovox code learning transmitters. To program the transmitters, disconnect power to the alarm for 10 seconds. Reconnect power and within 10 seconds, press button #1 of the first transmitter to be programmed.
  • Page 7 re-program the transmitters, repeat the above procedure. OPERATING YOUR SYSTEM: ARMING: 1. Exit your vehicle, and close all entry points. 2. Press button #1 of your keychain transmitter 1 time. The siren will emit a single tone indicating that the system is armed. The parking light will flash once and the starter inhibit relay will be engaged.

  • Page 8: Voltage Sensor

    TESTING THE VOLTAGE SENSOR: 1. Arm the alarm system by pressing button #1 of a programmed transmitter one time. The siren will chirp once confirming that the system is armed. 2. Wait 4 seconds to allow the unit to stabilize. 3.
  • Page 9 of 8 different sensitivity levels. To adjust or change the setting of your shock sensor dis- arm the system and within 8 seconds, simulta- neously press both buttons of your transmit- ter until the siren emits a low tone. This indi- cates that the unit is ready to accept a sensi- tivity level change.

  • Page 10: Operation At A Glance

    OPERATION AT A GLANCE: TRANSMITTER OPERATION PRESS BUTTON #1 1 TIME PRESS BUTTON #1 2 TIMES PRESS BUTTON #1 FOR 3 SECONDS PRESS BOTH BUTTONS FOR 2 SECONDS AUDIBLE + VISIBLE STATUS INDICATIONS: 1 CHIRP AND 1 PARKING LIGHTS FLASH 2 CHIRPS 2 PARKING LIGHTS FLASH 4 CHIRPS 3 PARKING LIGHTS FLASH WIRE LOOP CONFIGURATION...
  • Page 11 -11-...

  • Page 12: 12 Month Limited Warranty

    Applies to control modules, relays, transmitters, sensors, and sirens. AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced (at the Company's option) without charge for parts and repair labor.

Table of Contents